Plastic Water Feature Reservoirs
| Plastic Water Feature Reservoirs |
|
|
Very strong and sturdy water reservoirs which can be used for water features, ponds or holding tanks. They can be installed in the ground or free standing. When used for water features the Victoria ponds can be used in conjunction with the Metal Grids. Unlike other water feature reservoirs they will hold plenty of water.
Round Victoria Water Feature Reservoir Base Sizes: Victoria 60 - 670mm Dia x 350mm Deep and holds 90 litres
Rectangular Victoria Quadro Water Feature Reservoir Base Sizes:
Victoria Quadro 3 - 800mm Long x 630mm Wide x 380mm Deep and holds 150 litres
|
| Oase Auto Fill Kit The Oase Auto Fill Kit is a simple solution for automatically topping up a water feature sump or pump chamber. Evaporation or "splash out" can cause the water level within your pond or water feature to fall over time. With the installation of an Auto Fill Kit which is connected to a mains water supply, small amounts of water can be added at a time reducing the need for manual top-ups. The Oase Auto Fill Kit uses a simple and reliable "toilet cistern" type float valve which can be fitted to the flat surface of a plastic reservoir (through a 22mm diameter hole) and then connected to a mains water feed pipe. The Oase Auto Fill Kit Includes: • A float valve with a range of 38 - 45 mm between the lowest and the highest level water points • A "Snap" type hose connector Oase Auto Fill Kit Technical Limits ‚ Maximum water pressure : 5 bar (72 PSI) • Maximum flowrate 340 litres per hour (75 gallons per hour)
| |